Auto-Qos Configuration Example - Cisco Catalyst 3120 Software Manual

Chapter 36 Configuring QoS

Auto-QoS Configuration Example

This section describes how you could implement auto-QoS in a network, as shown in
optimum QoS performance, enable auto-QoS on all the devices in the network.
Figure 36-11
Figure 36-11
enabled on the switches in the network at the edge of the QoS domain.
OL-12247-01
Auto-QoS Configuration Example Network
Blade servers
Identify this interface
as connected to a
trusted switch or router
IP
Identify these
interfaces as
IP connected to
IP phones
Cisco IP phones
shows a network in which the VoIP traffic is prioritized over all other traffic. Auto-QoS is
Cisco router
Trunk Trunk
link link
Cisco
Blade
switch
Identify these
interfaces as
connected to
IP phones
Cisco Catalyst Blade Switch 3120 for HP Software Configuration Guide
Configuring Auto-QoS
Figure
To Internet
Video server
172.20.10.16
Identify this interface
as connected to a
trusted switch or router
IP
IP
Cisco IP phones
36-11. For
36-27