Cisco Catalyst 3120 Software Manual page 734

Catalyst blade switch for hp
Hide thumbs Also See for Catalyst 3120:
Table of Contents

Advertisement

Understanding QoS
These queues are assigned to a queue-set. All traffic exiting the switch flows through one of these four
queues and is subjected to a threshold based on the QoS label assigned to the packet.
Figure 36-10
the reserved pool. The switch uses a buffer allocation scheme to reserve a minimum amount of buffers
for each egress queue, to prevent any queue or port from consuming all the buffers and depriving other
queues, and to control whether to grant buffer space to a requesting queue. The switch detects whether
the target queue has not consumed more buffers than its reserved amount (under-limit), whether it has
consumed all of its maximum buffers (over limit), and whether the common pool is empty (no free
buffers) or not empty (free buffers). If the queue is not over-limit, the switch can allocate buffer space
from the reserved pool or from the common pool (if it is not empty). If there are no free buffers in the
common pool or if the queue is over-limit, the switch drops the frame.
Figure 36-10
Buffer and Memory Allocation
You guarantee the availability of buffers, set drop thresholds, and configure the maximum memory
allocation for a queue-set by using the mls qos queue-set output qset-id threshold queue-id
drop-threshold1 drop-threshold2 reserved-threshold maximum-threshold global configuration command.
Each threshold value is a percentage of the queue's allocated memory, which you specify by using the
mls qos queue-set output qset-id buffers allocation1 ... allocation4 global configuration command.
The sum of all the allocated buffers represents the reserved pool, and the remaining buffers are part of
the common pool.
Through buffer allocation, you can ensure that high-priority traffic is buffered. For example, if the buffer
space is 400, you can allocate 70 percent of it to queue 1 and 10 percent to queues 2 through 4. Queue 1
then has 280 buffers allocated to it, and queues 2 through 4 each have 40 buffers allocated to them.
You can guarantee that the allocated buffers are reserved for a specific queue in a queue-set. For
example, if there are 100 buffers for a queue, you can reserve 50 percent (50 buffers). The switch returns
the remaining 50 buffers to the common pool. You also can enable a queue in the full condition to obtain
more buffers than are reserved for it by setting a maximum threshold. The switch can allocate the needed
buffers from the common pool if the common pool is not empty.
Cisco Catalyst Blade Switch 3120 for HP Software Configuration Guide
36-18
shows the egress queue buffer. The buffer space is divided between the common pool and
Egress Queue Buffer Allocation
Chapter 36
Common pool
Reserved pool
Configuring QoS
OL-12247-01

Advertisement

Table of Contents
loading

Table of Contents