Default Rip Configuration; Configuring Basic Rip Parameters - Cisco Catalyst 3120 Software Manual

Chapter 38 Configuring IP Unicast Routing

Default RIP Configuration

Table 38-4
Table 38-4
Feature
Auto summary
Default-information originate
Default metric
IP RIP authentication key-chain No authentication.
IP RIP receive version
IP RIP send version
IP RIP triggered
IP split horizon
Neighbor
Network
Offset list
Output delay
Timers basic
Validate-update-source
Version

Configuring Basic RIP Parameters

To configure RIP, you enable RIP routing for a network and optionally configure other parameters. RIP
configuration commands are ignored until you configure the network number.
Beginning in privileged EXEC mode, follow these steps to enable and configure RIP:
Command
Step 1 configure terminal
Step 2 ip routing
Step 3
router rip
OL-12247-01
shows the default RIP configuration.
Default RIP Configuration
Default Setting
Enabled.
Disabled.
Built-in; automatic metric translations.
Authentication mode: clear text.
According to the version router configuration command.
According to the version router configuration command.
According to the version router configuration command.
Varies with media.
None defined.
None specified.
Disabled.
0 milliseconds.
•
•
•
•
Enabled.
Receives RIP Version 1 and 2 packets; sends Version 1 packets.
Purpose
Enter global configuration mode.
Enable IP routing. (Required only if IP routing is disabled.)
Enable a RIP routing process, and enter router configuration mode.
Cisco Catalyst Blade Switch 3120 for HP Software Configuration Guide
Update: 30 seconds.
Invalid: 180 seconds.
Hold-down: 180 seconds.
Flush: 240 seconds.
Configuring RIP
38-21