Securing Appliance To Stove Pipe/Liner; Standard Surround & Trim Installation - Quadra-Fire VOYA-GRAND-MBK Owner's Manual

R
E. Securing Appliance to Stove Pipe/Liner
1. Once you have the appliance in place and secured,
remove the tube channel assembly, baffle board and
ceramic blanket. Detailed instructions are found on
pages 23 and 24.
2. Reach up through the flue opening and grab the attach-
ment bar and pull down inside flue opening. Figure 41.1.
3. Insert the 5/16 bolts inside the cast flue and through the
chimney mounting bar. Securely tighten the nuts. Fas-
teners are provided.
4. Re-install the tube channel assembly, baffle board,
ceramic blanket and baffle protection channel.
Attachment
Bar
5/16 Nuts
Figure 41.1
May 23, 2013
5/16 Bolts
VOYAGEUR GRAND Wood Insert
F. Standard Surround & Trim Kit Installation
Standard Size: 43 in. W x 31 in. H
Large Size: 51 in. W x 34 in. H
1. Lay surround face down on a protected surface to pre-
vent scratching.
2. Using a 4 to 6 inches long Phillips head screw driver
attach the side surrounds to the top surround using (2)
#8 sheet metal screws on each side provided with the kit.
Figure 41.2.
3. Lay the trim face down and place the corner brackets into
position.
4. Using a standard flat screw driver tighten the corner
brackets. Figure 41.3.
5. Slide the assembled trim set over the surround set. and
then over the appliance matching the mounting tabs on
the side pieces with the slots on the appliance. Figure
41.2.
6. Align the 2 screws in the top surround piece to the 2
alignment holes on the appliance top. Secure in place.
Figure 41.2.
7. Use the strain relief in the surround side for blower cord
installation and use the cover plug to insert into the hole
where the blower cord is not installed.
Figure 41.2
Figure 41.3
7075-166C
Secure to
Firebox Face
Mounting Tabs
Slide into Slots
on Firebox Face
Strain Relief for
Blower Cord and
Cover Plug for hole
in each side
Corner Brackets
Page 41