Determining The 4-Digit Code - Radio Shack 15-1990 Owner's Manual

15-1990.fm Page 28 Tuesday, December 14, 1999 12:45 PM
Note: If your VCR's original remote does not have a
power key, manually turn on the device, insert a
tape, and repeat Steps 1–6, using
. When the device responds, press
POWER
red light blinks twice.

Determining the 4-Digit Code

After you set up your remote control using the man-
ual code search, you can find which 4-digit code the
remote control is set to by following these steps.
1. Press the device key (
to get the manufacturer's code from, then hold
down until the red light blinks twice.
P
2. Press ,
MUTE MUTE
blinks twice again.
3. Press , then count the number of times the
VOL +
red light blinks. This is the first digit of the 4-digit
code.
Note: If the red light does not blink, the digit is a
0.
4. Press , then count the number of times the
VOL –
red light blinks. This is the second digit of the 4-
digit code.
5. Press , then count the number of times the
CH +
red light blinks. This is the third digit of the 4-
digit code.
6. Press , then count the number of times the
CH –
red light blinks. This is the fourth digit of the 4-
digit code.
28
instead of
PLAY
P
, , or ) you want
TV VCR CBL
, then . The red light
VOL +
. The