Assemble Chest Press Seat - Precor move beyond S3.45 Assembly And Maintenance Manual

S3.45 Assembly and Maintenance Guide

17. Assemble Chest Press Seat

A. Place the Backpad and Headrest on the floor. Place
the Long Support Tube and Short Support Tube on
the Backpad. Attach at the top using
two 1¼-inch bolts
two washers
B. Attach at the bottom using
three 3-inch bolts
three washers
C. Attach the Backpad and Headrest assembly to the
Chest Press Upright using
one ½-inch x 5¼-inch bolt
two washers
one locknut
Finger tighten.
Note: The Stop Pad on the seat assembly should be
between the Pop Pin and the Support Stop on the
Chest Press Upright.
D. Wrench tighten, still allowing movement.
CAUTION: If you move the Handlebars out of
the way for this step, be careful that they don't
hit you.
E. Attach the Seat Pad to the Seat Stem using
two 1¼-inch bolts
two washers
Wrench tighten.
Step 17. Assemble Chest Press Seat
3 - 3" bolts Long
B
3 - washers Support
Tube
Short Support
Backpad
Tube
Long Support
Tube
Stop Pad
Pop Pin
Chest Press
Upright
1 - ½" x 5¼" bolt
C
2 - washers
1 - locknut
1 2
2 - 1¼" bolts
A
2 - washers
Headrest
Short
Support
Tube
Short
Support
Tube
2 - 1¼" bolts
E
2 - washers
The Backpad and Headrest are not
shown in this illustration.
3 4
Long Support Tube
Headrest
Backpad
Seat Pad
Seat Stem
5 6
page 30