Connection To Power Source - Fujitsu IP-900E Hardware User's Manual

Chapter 2 Installation and Connection
2.2.2

Connection to power source

IP-900E/IP-900D series operation requires a power supply of 100-240 VAC. Insert the power
cord with the standard two-prong plug with ground into the inlet connector.
The power cord is not supplied with the device. Procure it separately.
AC cord clamp
Insert the AC cord clamp into the AC cord clamp hole and fix the power cord as shown in
figure above. When remove the AC cord clamp, screw out and remove it with the mounting
kit.
IP-900E/IP-900D series
Figure Power cord connection
24