Air Flow Into And Out From The Device - Fujitsu IP-900E Hardware User's Manual

Hide thumbs Also See for IP-900E:

Hardware user's manual (116 pages)

Table Of Contents

100

101

102

103

104

Table of Contents

3) The installation of IP-900E/IP-900D series in a rack should be such that

the amount of airflow required for safe operation of IP-900E/IP-900D

series is not compromised.

IP-900E/IP-900D series has ventilation opening at the right and

rear side.

Do not cover or close these ventilation openings to prevent

overheating.

4) The mounting of IP-900E/IP-900D series in a rack should be such that a

hazardous condition in not archived due to uneven mechanical loading.

To keep stability of the entire rack, please fix the rack to wall or floor

by suitable means.

Be careful about injury during installation of IP-900E/IP-900D

series into rack.

Do not install IP-900E/IP-900D series into your rack where

IP-900E/IP-900D series may make the entire rack unstable.

The weight of IP-900E/IP-900D series with the maximum

configuration: 2.3 kg

5) If IP-900E/IP-900D series is supplied from the power strip or the

service outlet of other units, it may overload the power supply cord of

the power strip or other units.

Confirm that the current rating of the power strip or the service

outlet exceeds the combined ratings of all equipment is supplying.

The electrical rating of IP-900E : Rated 100-240 VAC, 50/60 Hz, 1

phase, 0.38 - 0.20 A(IP-900E)/0.33 - 0.17 A(IP-900D) /0.35 - 0.18 A

(IP-900IID).

6) The reliable earthing of the rack-mounted equipment must be

maintained.

connections other than direct connections to the branch circuit (e.g., use

of the power strips or the power distribution unit).

Note: The high leakage current may flow through the power strip

earthing conductor if all power supply cords of IP-900E/IP-900D series

are connected to one power strip. The earth connection is essential

before connecting supply. If the power strip is not directly connected to

the branch circuit, the power strip which has the industrial type

attachment plug should be used.

7) For installing, IP-900E/IP-900D series shall be installed near the

wall-outlet and the wall-outlet shall be easily accessible.

2.1.3