Connection To Power Source - Fujitsu IP-9610 Hardware User's Manual

2.2.2 Connection to power source

IP-9610 operation requires a power supply of 100-240 VAC. Insert the power cord with the
standard two-prong plug with ground into the inlet connector.
The power cord is not supplied with the device. Please procure it separately.
Power inlet connector
1
2
AC cable clamp
Insert the AC cable clamp into the AC cable clamp hole and fix the power cord as shown in figure
above. When remove the AC cable clamp, screw out and remove it with the mounting kit.
Cable holder
Figure Power cord connection
19
Chapter 2 Installation and Connection
3
4
IP-9610