Chapter 2 Installation and Connection
2.2.2
Connection to power source
IP-920E/IP-920D operation requires a power supply of 100-240 VAC. Insert the power cord
with the standard two-prong plug with ground into the inlet connector.
The power cord is not supplied with this equipment. Procure it separately.
Power inlet connector
100-240V
AC cord clamp
Insert the AC cord clamp into the AC cord clamp hole and fix the power cord as shown in
figure above. When remove the AC cord clamp, screw out and remove it with the mounting
kit.
IP-920E/IP-920D
10/100BASE
RS-232C
E
100M
PWR ALM
OPT
LINK
RDY
IN
/ACT
DWN
FG
MNT
Figure Power cord connection
ANALOG AUDIO IN
Cable holder
36