Device Settings And Operation - Fujitsu IP-900E Hardware User's Manual

Chapter 3 Operation Instructions
3.2
3.2
■Setup Procedure
The setup procedure is shown below.
See Software User's Guide for the procedure of the software installation and the each setting.
Connect IP-900 and PC
using UTP cable
Power ON
Change network settings
Reboot
Connect user's network
Start settings and operations
(Refer the software user's guide)
■Web browser recommended
The recommended web browser is as follow.
- Internet Explorer 6.0 SP2 or later
IP-900E/IP-900D series

Device Settings and Operation

- Check if IP-900 is disconnected to user's network.
- Connect using UTP cable.
- When connect through LAN port, the default IP address and subnet
mask are 10.0.0.1 and 255.0.0.0 respectively. Assign 10.xxx.xxx.xxx for PC.
(ex. IP address: 10.0.0.2, Subnet mask: 255.0.0.0)
for PC.
See Section 3.3, "Operation Management."for more details.
- After rebooted, start setting from WEB GUI.
See Section 3.3, "Operation Management" of the software user's
guide for mode details.
- After rebooted, connected to the user's network and set up the various
parameters. See Section 3.2.2, "Reboot" for more details.
36