User Preferences <User_Preferences; Flash Parameter Configuration - Polycom SIP 3.0.2 Administrator's Manual

User Preferences <user_preferences/>
Attribute
up.analogHeadsetOpti
on

Flash Parameter Configuration

Caution
This configuration attribute is defined as follows:
Permitted
Values Default
0, 1 0
Any field in the bootROM setup menu and the application SIP Configuration
menu can be set through a configuration file.
A DHCP server can be configured to point the phones to a boot server that has
the required configuration files. The new settings will be downloaded by the
phones and used to configure them. This removes the need for manual
interaction with phones to configure basic settings. This is especially useful for
initial installation of multiple phones.
These device settings are detected when the application starts. If the new
settings would normally cause a reboot if they were changed in the application
Network Configuration menu, then they will cause a reboot when the
application starts.
The parameters for this feature should be put in separate configuration files to
simplify maintenance. Do not add them to existing configuration files (such as
sip.cfg). One new configuration file will be required for parameters that should
apply to all phones, and individual configuration files will be required for
phone-specific parameters such as SIP registration information.
The global device.set parameter must be enabled when the initial
installation is done, and then it should be disabled. This prevents subsequent
reboots by individual phones triggering a reset of parameters on the phone
that may have been tweaked since the initial installation.
Interpretation
Selects optional external hardware for use with a headset
attached to the phone's analog headset jack.
If set to 0, no compatible headset is attached.
If set to 1, a DHSG-compatible headset is attached and
can be used as an electonic hookswitch.
Configuration Files
A - 105