Insert Tools, Accessories; Technical Data - Hilti TE 7-C Operating Instructions Manual

2.9 Using extension cords outdoors
When working outdoors, use only extension cords that are approved and correspondingly marked for this
application.
2.10 Using a generator or transformer
en
This power tool may be powered by a generator or transformer which fulfills the following conditions: The unit
must provide a power output in watts of at least twice the value printed on the rating plate on the power tool.
The operating voltage must remain within +5% and -15% of the rated voltage at all times, frequency must be in
the 50 – 60 Hz range and never above 65 Hz, and the unit must be equipped with automatic voltage regulation
and starting boost.
Never operate other power tools or appliances from the generator or transformer at the same time. Switching
other power tools or appliances on and off may cause undervoltage and / or overvoltage peaks, resulting in
damage to the power tool.

3. Insert tools, accessories

Designation
Chucks
Hammer drill bits
Forming and installation drill bits
Lightweight percussion core bits
Multipurpose hole saws
Pointed chisel
Flat chisel
Shaped chisels
Anchor-setting tools
Quick-release chuck for wood and metal drill bits
Key-type chuck
Wood drill bits
Metal drill bits
Metal drill bits / stepped drill bits
Designation
Dust module
Angular chuck

4. Technical data

Right of technical changes reserved.
NOTE
The power tool is available in various voltage ratings. Please refer to the power tool's type identification plate
for details of its rated voltage and rated input power.
4
Description
TE‑C CLICK
Ø 5...28 mm
Ø 5...20 mm
Ø 25...68 mm
Ø 25...82 mm, hexagonal
C-type connection end
C-type connection end
C-type connection end
C-type connection end
For smooth or hex. shank
With smooth or hex. shank
Ø 3...20 mm
Ø Max. 13 mm
Ø 5...22 mm
Description
TE DRS-M
C-type connection end