Description - Hilti TE 7-C Operating Instructions Manual

Obligation signs
Wear eye Wear a hard
en
protection hat
Wear
breathing
protection
Symbols
Read the Return waste
operating material for
instructions recycling.
before use
Chiseling Chisel position
adjustment

2. Description

2.1 Use of the product as directed
The power tool is an electrically-powered rotary hammer with pneumatic hammering mechanism.
The power tools are designed for drilling in concrete, masonry, gypsum board (drywall), wood, plastic and
metal. The power tool can also be used for light chiseling work on masonry and surface finishing on concrete.
Working on materials hazardous to the health (e.g. asbestos) is not permissible.
The power tool is designed for professional use. The power tool may be operated, serviced and repaired
only by authorized, trained personnel. This personnel must be informed of any special hazards that may be
encountered.
The power tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel
or when used not as directed.
The working environment may be as follows: construction site, workshop, renovation, conversion or new
construction. The power tool may be operated only when connected to a power supply providing a voltage and
frequency in compliance with the information given on its type identification plate.
Changes or modifications to the power tool are not permissible.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
2
Alternating
current
Wear ear Wear
protection protective
gloves
Diameter
Location of identification data on the power tool
The type designation can be found on the type iden-
tification plate and the serial number on the side of
the motor housing. Make a note of this data in your
operating instructions and always refer to it when
making an enquiry to your Hilti representative or
service department.
Drilling Hammer
Type:
without drilling
hammering
Serial no.:
Volts Amps
Hertz Rated speed Revolutions
under no load per minute
Double Reverse Forward
insulated rotation rotation