Disposal; Manufacturer's Warranty - Tools - Hilti TE 7-C Operating Instructions Manual

Fault
The power tool doesn't
achieve full power.
en
The drill bit doesn't rotate.
The drill bit can't be released.
The drill bit makes no pro-
gress.

10. Disposal

Most of the materials from which Hilti power tools or appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, Hilti has already made
arrangements for taking back your old power tools or appliances for recycling. Please ask your Hilti customer
service department or Hilti representative for further information.

11. Manufacturer's warranty - tools

Hilti warrants that the tool supplied is free of defects
in material and workmanship. This warranty is valid
so long as the tool is operated and handled correctly,
cleaned and serviced properly and in accordance with
the Hilti Operating Instructions, and the technical
system is maintained. This means that only original
Hilti consumables, components and spare parts may
be used in the tool.
This warranty provides the free-of-charge repair or
replacement of defective parts only over the entire
lifespan of the tool. Parts requiring repair or replace-
ment as a result of normal wear and tear are not
covered by this warranty.
12
Possible cause
The extension cord's conductor
cross section is inadequate.
The control switch is not pressed
fully.
The function selector switch is not
engaged or is in the "Chiseling" or
"Chisel adjustment" position.
The chuck is not pulled back fully.
The forward/reverse switch is set
to reverse rotation.
Additional claims are excluded, unless stringent na-
tional rules prohibit such exclusion. In particular,
Hilti is not obligated for direct, indirect, incidental
or consequential damages, losses or expenses in
connection with, or by reason of, the use of, or
inability to use the tool for any purpose. Implied
warranties of merchantability or fitness for a par-
ticular purpose are specifically excluded.
For repair or replacement, send the tool or related
parts immediately upon discovery of the defect to
the address of the local Hilti marketing organization
provided.
This constitutes Hilti's entire obligation with regard
to warranty and supersedes all prior or contempor-
aneous comments and oral or written agreements
concerning warranties.
Remedy
Use an extension cord with an ad-
equate conductor cross section.
(Please refer to the "Description"
section.)
Press the control switch as far as it
will go.
When the motor has stopped, turn
the function control switch to the
"Drilling without hammering" or
"Hammer drilling" position.
Pull the chuck back as far as it will
go and remove the insert tool.
Set the forward/reverse switch to
forward rotation.