Appliance Setup; Remove Glass Assembly; Clean The Appliance; Air Shutter Access & Adjustment - Heat & Glo LUX60 Owner's Manual

15 15

Appliance Setup

WARNING! Risk of Fire and Electric Shock!
Hearth & Home Technologies-approved optional acces-
sories with this appliance. Using non-listed accessories
could result in a safety hazard and will void the warranty.
A. Remove Glass Assembly
WARNING! Risk of Asphyxiation!
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fi replace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
The glass assembly can be removed from the unit by
pulling and releasing the glass latches. There are three
across the top, three across the bottom, and one in the
center of each side.
The glass assembly is heavy. Use caution when remov-
ing.
Latches
Figure 15.1 Glass Assembly Removal
B. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the fi rebox or underneath in the control cavity.
Use ONLY
Handle fi xed glass
Glass
Heat & Glo • LUX60 • 4062-116 • Rev. G • 4/11
C. Air Shutter Access & Adjustment
• Outside Burner Tube Air Shutter
- Disconnect power to fi replace.
- Remove the "L" plates and inner surround frame
(see surround install). This will make the valve
compartment and glass accessible. (Refer to Section
3.A. Glass Cleaning.)
Note: Mark and note burner tube locations.
They are not interchangeable (Figure 15.2).
LH Burner Tube Back Burner Tube
Figure 15.2 Burner Tube ID
RH Burner Tube
49