Pioneer SD-P4053 Operating Instructions Manual page 26

HOW TO ALIGN COLOR CONVERGENCE
Notes for the convergence alignment
adjustment
5 R/B key
By repeatedly pressing the 5 R/B key or the MENU SET but-
ton when the convergence alignment adjustment is en-
gaged, a selected image can be displayed on the screen in-
stead of the alignment cross pattern,
This is the alignment proof mode, which a}lows you to check
the center of the images to ensure that colored borders are
not seen after the adjustment.
In the alignment proof mode the alignment can also be ad-
justed by pressing the 2, 4, 6 and 8 keys or pressing
the MENU SELECT/ADJUST button. However, it is difficult
to adjust the alignment propedy when only the images ap-
pears on the screen.
If you can still see colored borders around the images, press
the 5 R/B key or the MENU SET button again until the prop-
er convergence alignment pattern reappears, and adiust the
alignment by following the operations described on the pre-
vious page.
After all convergence aJignment adjustment is finished,
press the MENU ON/OFF button to set the monitor to its
normal mode.
Each time the 5 R/B key is pressed, the alignment adjust-
ment mode will change as follows:
Red (Al',gnmem
_ pattern appears}
Blue
(Selected image
only appears)
IAlignment proof
mode[
Blue INignment
--" pattern appears) "-_
/
Red (Selected image j
only appears) _._
[Alignment proof
mode]
Convergence alignment adiostment can be performed by
pressing the 2, 4, 6 and B keys on the remote control after
the alignment mode is selected.
Each time the MENU SET button Is pressed, the alignment adjustment will change as follows:
r
Red-vertical adjustment
_Alignment pattern appears)
1
B_eohorizontal adjustment _
(Selected image only appears) j
[Alignment proof mode] I
l '
I
r
Blue-vertical adjustment I, FR_-d._or_-zont_-a_iustment
I (Selected image only appears) ,_---- Selected image only appears)
_Alignment proof mode] j [Alignment proof model
r t,-. -- -- , .
---. Red-horizontal adjustment _L__I Blue-vertmal adjustment
(Alignment pattern appears) -- j
Red-vertical adjustment
(Selected image only appears)
JAlignment proof mode I
I
i(Alignment pattern appears) I
i l i
I I
iBlue-horizontal adiustment I
L(Alignment patlern appears) l
F
1
I
26
Convergence alignment adjustment can be performed by'
pressing the MENU SELECT/ADJUST button on t_le fron_
Js s_ ec.ed
panel after toe alignment mode ,=_