Table of Contents
Advertisement
How to program the remote control buttons
[]
Set the LEAN MODE switch to LEARN.
]
Place the other remote control unit and the program-
mable remote control unit on a table facing each other,
separated by e distance of 2 to 4 inches (5 to 10 cm).
Programming will not be possible if the units are too close
to each omer
[]
Press the key on the programmable
remote control unit
that yoy wish to program until the TRANSMIT/LEARN
indicator lights up.
[]
Press a key on the other remote control unit until the
TRANSMITILEARN
indicator goes off.
[]
To program other keys, repeat steps 3 and 4.
[]
When finished, set the LEARN MODE switch back to the
USE position.
[]
Point the programmable
remote control unit toward the
corresponding
component
and
check operation
by
pressing the keys you just finished programming.
If the component
does not work as expected, repeat steps
1 to 7 Try changing the distance between the remote con-
trol units in step 2.
NOTE:
• When programming,
make sure that funcbon indicators (e g, _,
J_-, •) are programmed
from the original remote control unit in-
to the matching keys of the programmable
unit; this will greatly
facilitate operation.
coo not prets the keys excessively whde performing programm-
ing operahons,
• The TRANSMIT MODE switch w#lshut off automahcally while per.
forming programming
operettons.
eft the LEARN indicator flashes, it indicates ellher that you are tynng
to store a command with a key incapable of being used with the
LEARN function or that the remote control unit's programming
capaclly has been exceeded. In the latter case, the function last
programmed
will not be stored carrectly
All previously
pro-
grammed functions, however, will be retained in the memory and
may be used as they are if the last function _snot essenttaL
For re-programming
tnformabbn, refer to "Retum!hg to the In.
itlal Settings,"
I, ff programming
is not carried out successfully,
oPosttJonthe remote control units at a greater distance from each
other.
oposllion the remote control unitsslightly out of hne with each other
2
If the remote control unll _sd_rectly SUblected to strong fluores-
cent light, programming
may not be possible
3
ffremotecontroloperatlonlsnotsuccessfulallhoughprogram-
ming was successfuh
• Press the RESET button. (The programmed
signals w#! not t_e
erased)
ff the problem still cannot be corrected, press the M, CLR but-
ton and try programming
again.
oA/ter programming
zscompleted
set the LEARN MODE sw;tch
to the USE pos_bon.
How to use the remote control buttons
(_
Set the LEARN MODE switch back to the USE position
Q
Point the programmable
remote control uniI toward the cor-
responding component and check operation by pressing the
keys you just finished presetting.
2 to 4 inc,hes
I
1333
]3_
[
)
f
l
IIIIIIIII/I///III/IIIIIIIIIII/I,
t 6
37
21
Advertisement
Table of Contents
