Table of Contents
Advertisement
Remove the four #8 x 3/4" Screws (14) and care-
fully remove the Motor Hood (61).
61
14
Locate the Reed Switch (44) and the Magnet (43)
on the left side of the Pulley (42). Turn the Pulley
until the Magnet is aligned with the Reed Switch.
Make sure that the gap between the Magnet and
the Reed Switch is about 1/8 in. (3 ram). If nec-
essary, move the Reed Switch slightly using a slot-
ted screwdriver. Reattach the Motor Hood (not
shown) with the six #8 x 3/4" Screws (not shown).
Run the treadmill for a few minutes to check for a
correct speed reading.
1/8 in. l
44-
Top
View
¢%
o
o I
- 43
_42
PROBLEM:
The incline of the treadmill
does not change correctly
SOLUTION:
a. With the key in the console, press one of the Incline buttons. While the incline is changing,
re-
move the key. After a few seconds, re-insert the key. The treadmill will automatically
rise to the
maximum incline level and then return to the minimum level. This will recalibrate the incline system.
PROBLEM:
The walking
belt slows when walked on
SOLUTION:
a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 14.
b.
If the walking belt is overtightened, treadmill perfor-
mance may decrease and the walking belt may be-
come damaged. Remove the key and UNPLUG
TIlE POWER CORD. Using the hex key, turn both
idler roller bolts counterclockwise,
1/4 of a turn.
When the walking belt is properly tightened, you
should be able to lift each edge of the walking belt
2 to 3 in. (5 to 7 cm) off the walking platform. Be
careful to keep the walking belt centered. Then,
plug in the power cord, insert the key, and run the
treadmill for a few minutes. Repeat until the walk-
ing belt is properly tightened.
213
'
Idler Roller Bolts
c. If the walking belt still slows when walked on, see the front cover of this manual.
23
Hide quick links:
Advertisement
Table of Contents
