Assembly - NordicTrack TRL 625 831.298960 User Manual

ASSEMBLY
Assembly requires two persons. Place all parts of the recumbent cycle in a cleared area and remove the pack-
ing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included tools and your own adjustable wrench _.
Use the drawings below to identify the small parts used in assembly.The number in parenthesis below each
drawing refers to the key number of the part, from the PART LIST on page 14. The second number refers to the
quantity needed for assembly. Note: Some small parts may have been pre-attached for shipping. If a part is
not in the parts bag, check to see if it has been pre-assembled.
M6 Nylon M6 Split M6 Flat Console M10 Split
Locknut (71)-4 Washer (57)-4 Washer (67)-4 Washer (93)-4 Washer (87)-4
M8 Flat Washer M4 x 16mm M6 x 12.7mm
(89)-4 Screw (64)-1 Button Screw (62)-4
M6 x 16mm
Button Screw (68)-8
Console M 10 x 25mm M6 x 35mm
Screw (63)-4 Screw (88)-4 Screw (70)-4
1. Attach the Stabilizer (8) to the Frame (1) with four
M10 x 25mm Screws (88) and four M10 Split
Washers (87).
5