Magnavox VR3440 Owner's Manual page 28

28
llTiTlliild lil_.li{t I i|r|_l i |_I |j ll=.],'{di_l ti I _ 1_II :f_i:ll
Use this connection if your cable system connects directly to your TV without a converter box.
CATVInput
In from Antenna
Outto TV
Back of TV
:Panel "
i
I
With this connection, you can 1) use your VCR Remote Control to select channels 2) program one or more unscrambled
channels for unattended recording 3) view one channel while recording another.
I NOTE: eYou can also use the VCR CHANNEL UP/DOWN button to select the desired channel.
oYou cannot record or view scrambled channels with this connection.
Outto TV
With this connection, you can record and view any channel including scrambled channels. However, channel selection must be
1,aade at the cable company converter box. This means that channels cannot be changed using the VCR Remote Control.
Unattended recording is limited to one channel at a time, and you cannot view any channel other than the one you are
recording..
To Record and View a Scrambled/Unscrambled Channel
1. Set the VCR/TV selector located on the front of the VCR to "VCR".
2. Set the TV channel selector to the output channel of the VCR (channel 3 or 4).
3. Set the VCR channel selector to the output channel of the Cable Converter Box. (If the Cable Converter Box is set to channel
3, the VCR should be set to channel 3. If the Box is set to channel 4, the VCR should be se! to channel 4.).
4. Select the channel to be recorded at the Cable Converter Box.
To Watch TV (with the VCR off)
l. Set the TV channel selector to the output channel of the Cable Converter Box.
2. Select the channel on the cable converter channel selector.