Timer Recording - Philips DVD740VR Owner's Manual

Timer Recording (cont'd) 37
Checking or Cancelling Timer Recordings
#_ Before you begin, place the DVD/VCR in VCR mode.
Press OUTPUT SELECT so the green VIDEO light appears on
the front of the
DVD/VCR.
With the DVD/VCR on and in VCR mode and in VCR
position (press VCR/TV so the green VCR/TV light appears
on the front of the DVD/VCR), press VCR, then press
DISC/MENU.
Press PLAY I_ (A) or STOP • (v) to select PRO-
GRAM, then press FF I_1_ (1_).
3
4
5
Press PLAY I_ (A) or STOP • (v) to select PRO-
GRAM REVIEW, then press FF Ipl_ (1_). The timer
recording information for the program in the lowest num-
bered slot will appear on the screen. If no timer recordings
are set, nothing will happen when you press FF I_I_ (I_).
Press FF I_ 0_) repeatedly to review all pro-
grammed timer recordings. If you don't press FF I_l_
(1_) within 10 seconds, the DVD/VCR will automatically
display information about the next programmed timer
recording, This will continue until all timer recordings have
been displayed. Then the menu will disappear.
To cancel the timer recording displayed, press
CLEAR. Either the display will disappear or information
about other timer recordings will appear. If you do not
press any other buttons, the display will disappear after all
timer recordings have been displayed.
Repeat steps 1-4 to make sure you have cleared the
correct timer recording.
CLASH may flash on the screen when
you finish setting a timer recording.
The timer recording you just tried to
program overlaps another timer
recording. The timer recording you
were trying to set will not occur. You
may cancel the other overlapping
timer recording.
To stop a started timer recording,
press STOP/EJECT or TIMER on the
front of the DVDNCR.
Power failures will erase timer record-
ings.
If the preset time for a timer record_
ing comes up during an OTR, the
OTR has priority. A message will
remind you when the timer recording
was scheduled to begin. You may let
the OTR continue; the timer recording
will not take place. Or, press
STOP
• (v) to stop the OTR and press
TIMER SET immediately. The timer
recording will take place if you press
TIMER SET before the timer record_
ing's scheduled start time.
ee page 76 for more hints,