GE Appliances PT925 Owner's Manual page 30

Before gou call for service...
Troubleshooting Tips
E.cessue smoki"g
during a clean cycle
Possible Causes
This is the sound of the
metal heating and cooling
during both the cooking and
cleaning functions.
Excessive soil.
What To Do
• This is normal.
• Touch the CLEAR/OFFpad. Open the windows to
rid the room of smoke. Wait until LOCKEDgoes off.
Wipe up the excess soil and reset the clean cgcle.
Oven door will not Oven too hot. • Allow the oven to cool below locking temperature.
open after a clean cgcle
Oven not clean after Oven controls not properlg set. • Seethe Using the self-cleaning oven section.
a clean qjcle Oven was heavilg soiled. • Clean up heavy spillovers before starting the clean
cgcle. Heavilg soiled ovens mag need to self-clean
again or for a longer period of time.
"LOCKED"flashes The self-clean cgcle has been • Closethe oven door.
in the display selected but the door is not
closed.
"LOCKED"is on The oven door is locked • Touch the CLEAR/OFFpad. Allow the oven to cool.
when you want because the temperature
to cook inside the oven has not
dropped below the
locking temperature.
"F--and a number You have a function error code. • Disconnect all power to the oven for
or letter" flash at least 30 seconds and then reconnect power.
in the display
If the function error code repeats, call for service.
"LOCKED"appears The controls have • Seethe Contro! Lock section to unlock.
in the oven displag been locked.
Control signals after You forgot to enter a • Touch the BAKEpad and desired temperature or
entering cooking time bake temperature or the SELFCLEANHI/LO pad and desired cleon time.
or start time cleaning time.
Displag goes blank A fuse in gour home mag be • Replacethe fuse or reset the circuit breaker.
blown or the circuit breaker
tripped.
The clock is in the • Seethe Specialfeatures of your oven contro! section.
black-out mode.
Displag flashes Power failure. * Resetthe clock.
Unable to get the
Oven control pads were • The BROIL HI/LO and BAKE pads must be touched
display to show "SF" not touched properlg, at the same time and held for 3 seconds.
"Probe" appears This is reminding gou to • Entera probe temperature.
in the display
enter a probe temperature
after plugging in the probe.
30