GE Appliances PT925 Owner's Manual page 27

Electric self-cleaning convection built-in oven
Hide thumbs Also See for Appliances PT925:
Table of Contents

Advertisement

Available languages

Available languages

GEAppliances.com
j
j SHOCK OR BURN HAZARD: Before replacing oven light bulb, disconnect
-&WARNING
j the electrical power to the oven at the main fuse or circuit breaker panel.
Failure to do so mag result in electric shock or burn,
i
i BURN HAZARD: The glass cover and bulb should be removed when cool.
_4, C AUTION
Touching
hot g lass with b are h ands oradamp cloth c an cause burns
Socket
Receetacle
_
G6.35Bulb
Ghss cover
(onsome models)
Oven Light
Replacement
(on some models)
To remove:
[-_ Turn the glass cover counterclockwise
1/4 turn until the tabs of the glass
cover clear the grooves of the socket.
Wearing latex gloves may offer
a better grip.
[_
Using gloves or a drg cloth, remove
the bulb by pulling it straight out.
To replace:
I_
Use a new !20/!50-volt
halogen bulb,
not to exceed 50 watts. Replacethe
bulb with the same type of bulb that
was removed.Your model will have
one of the two types shown on
the left. To determine the correct
replacement bulb, check the bulb
terminals. Bulbs with 2 straight pin
terminals are G6.35 bulbs. Bulbs
with 2 looped terminals are G9 bulbs.
(Donot interchange.) Be sure the
replacement bulb is rated 120 volts
or 130 volts (NOT12 volts).
[]
Using gloves or a drg cloth, remove
the bulb from its packaging. Do not
touch the bulb with bare fingers. Oil
from skin will damage the bulb and
shorten its life.
Receptacle
[]
Usegtoyes
or cloth
Pushthe bulb straight into the
receptacle all the wag.
Placethe tabs of the glass cover into
the grooves of the socket. Turn the
glass cover clockwise 1/4 turn.
For improved lighting insidethe oven,
clean the glass cover frequentlg using
a wet cloth. This should be done when
the oven is completely cool.
[_
Reconnect electrical power to
the oven.
GlassCover
(onsomemodels)
Oven Heating
Elements
Do not clean the heating elements.
Any soil will burn off when the elements
are heated. Clean the oven floor with
warm, soapy water.
Wipe up heavysoil onthe oven bottom.
NOTE:Do not attemptto lift the heating
element.Doing socould damage
the element.
27

Advertisement

Table of Contents
loading

Table of Contents