GE Appliances GSD4410 Owner's Manual page 12

About the display diagnostic codes.
What It Means
_ Electrical power to the
dishwasher has been
RESET interrupted but is now
back on.
What To Do
IF DISHWASHER WASIN USEWHEN
THEPOWERFAILURE OCCURRED:
I Press the RESETpad and wait
approximately 30 seconds.
2 Unlatch and open the door.
A ff the detergent cup is open and
empty and the dishwasher was set
for the NORMAL POTSPANSor
CHINACRYSTAL cycle, close
door and put the load through a
RINSEHOLD cycle Atier the
RINSEHOLDcycle is completed,
add detergent and reset the load
for the washing Q'cle you want.
B If the detergent cup is closed and
the dish'_asher was set for the
NORMAL POTSPANSor
CHINACRYSTAL c ycle, reset the
dishwasher lor the _lsh cycle
you want.
F !
L I
C If the dishx_sher was set for the
RINSE HOLDcycle, reset the
dishwasher tbr RINSEHOLD.
IF THE DISHWASHER WAS NOT IN USE
when power t_tilure occulted, use
dish_asher as you normally would.
Slow draining. The
dishwasher is taking
longer than normal to
drain the water out.
This is usually caused
by a blockage in the drain
air gap, a kink in the
drain hose, or a
stopped-up pipe.
This dishwashel is designed to
autoinatically colnpensate for longer
than noz_nal drain times, hut cycle time
will be extended. If this code continues
to appear frequendy:
I (;lean the air gap.
2 Check for a kink in the drain hose.
3 Check plumbing ti)r slow or
stopped-up dndns.
NOTE: W a_Tanty sezYice does not
cover household dndn problems.
12