Lanier LD1110 Settings Manual page 55

❖ System Status/Job List Display Time
You can specify how long to display the System Status and Job List display
for.
• On
• Off
By selecting [On], you can specify a display time between 10 and 999 seconds.
The timing is set to "15 second(s)" by default.
❖ Time Interval between Printing Jobs
You can set the length of interval between the end of a job and the start of a
new job.
If you select "Set Time", enter the time, 0 - 999 seconds (in 1 second incre-
ments), using the number keys. Default value is 3 seconds.
• Set Time
• Do not set
❖ ADF Original Table Elevation
You can set the timing for elevating the ADF original table.
• When original is set
• When [Start] is pressed
❖ ADF Feed Speed
When you use thick paper, you can slow down the printing speed to avoid
fusing the image by selecting [slow].
• Normal
• Slow
❖ Optimum for Thick Paper
You can set the optimum for thick paper to On or Off.
• On
• Off
❖ Key Repeat
You can enable or disable repetition of an operation if a key on the screen or
control panel is pressed continuously.
• Off
• Normal
• Repeat Time: Medium
• Repeat Time: Long
General Features
2
47