Machine Does Not Print - Lanier Printer Unit Type 40 RCP40 Operating Instructions Manual

Machine Does Not Print

Possible Cause
Is the power on?
Is the interface cable prop-
erly connected?
Are you using the correct
interface cable?
Did you connect the inter-
face cable after turning on
the main switch?
Is the machine Auto On
Line?
Is the specified paper set?
Are there any error mes-
sages on the display pan-
el?
Does the Error indicator
stay red?
Is the Data In indicator
blinking or lit?
Can you make a proof
print?
Is "Waiting" displayed?
If you cannot solve the problem by taking the preceding actions, contact your
sales or service representative.
Note
❒ If the Data In indicator is not blinking or lit, you can check the computer port
settings using the following procedure:
❖ ❖ ❖ ❖ If the machine is connected to the computer using the interface cable
❒ Make sure the computer port settings are correct. For a parallel port con-
nection, port LPT1 or LPT2 should be set.
• Windows 95/98/Me
A Click [Start], point to [Settings], and then click [Printers].
B
Click to select the icon of the machine. Next, on the [File] menu, click
[Properties].
Turn on the machine.
Connect the interface cable properly.
If there are any connectors or screws, make sure that they are fas-
tened securely.
Be sure to use the correct one. If the cable is damaged or worn, re-
place it with a new one.
Be sure to connect the interface cable before turning on the main
switch.
Bring it Auto On Line by pressing the { { { { Auto On Line} } } } key.
Set the specified paper in the Paper Feed Tray.
Check the error message, and take the required action.
Check the error message, and take the required action.
If it is not, the data does not reach the machine. Check the printer
cable connection. Also confirm that the printer port settings are
correct.
If you cannot print a system configuration list or a PS Font List
from the machine, the machine might be out of order. Contact
your sales or service representative.
Perform one of the following procedures:
• Wait until the job is finished.
• Cancel by pressing [Job Reset] (When using Type B, press the
{ { { { Job Reset} } } } key).
Machine Does Not Print
Solutions
4
35