Table of Contents
Advertisement
Using the Control Panel
Online Parameter Settings
No.
Mode
1
Set aut-O/L def.
2
Print Size def.
3
List/Test Print
5
5
IP Address
6
Ethernet Speed
7
Network
8
I/O Timeout
42
Description
Sets Auto On Line to "ON" or "OFF" when the power has been
turned on, or when the mode has been cleared.
Note
❒ Default: ON
Sets the print size selected when the power has been turned on or
when the mode has been cleared.
Note
❒ Default: Auto
Prints the current set content of this machine.
Note
❒ Default: System Print
Sets the IP Address.
Note
❒ Default: 011.022.033.044
Reference
See Printer Reference 1 for information about the IP Address
setting.
Sets the Ethernet communication speed.
Note
❒ Default: Auto
Sets the Network boot.
Note
❒ Default: None
Reference
See Printer Reference 1 for information about the Network boot
setting.
Sets the time to enable the interface after data stops being re-
ceived. When the time set here is exceeded, it will be possible to
receive data from the other interface.
Important
❒ If the set time is too short, a time out might occur while one
data is being received. As a result, data from another interface
might cut in and be printed, or the emulation retrieval from
half of the data may be activated, and be replaced with a dif-
ferent emulation.
Note
❒ Default: 30 sec.
Advertisement
Table of Contents
