Dipswitch Settings - SATO LM408 Operator's Manual

DIPSWITCH SETTINGS

This chapter identifies the functions of the printer's integrated dipswitches. The dipswitch complex is located on the
printer's operator panel and is an integral part of its configuration by enabling/disabling various operational
features. Refer to the table below on switch designation and their specific functions.
ATTENTION: Each dipswitch must be set for the printer to properly function. Address
all eight switches individually, but some may not require change.
NOTE: A small, flat tool similar to a screwdriver is required to alter dipswitch position.
When changing a switch setting, ensure that it has been moved fully up or down.
NOTE: The switches are arranged horizontally, from left to right, and oriented
vertically. The ON position is always upward and the OFF position is always
downward.
DIPSWITCH FUNCTIONS
SWITCH
1
2
3
4
5
6
7
8
LM408-412e Operator Manual
Unit 4: Printer Configuration
SETTING
ON Direct Thermal Printing
OFF Thermal Transfer Printing
ON Enable Eye-Mark Sensor
OFF Enable Gap Sensor
ON Enable Headcheck Feature
OFF Disable Headcheck Feature
ON Enable Hex Dump Feature
OFF Disable Hex Dump Feature
ON Enable Multi-Buffer Interface Receive Mode (periodic response)
OFF Enable Single-Buffer Interface Receive Mode (ENQ response)
ON Enable Download Mode Feature
OFF Disable Download Mode Feature
ON Enable Control Code Feature
OFF Disable Control Code Feature
ON Enable 203dpi Print Resolution
OFF Enable 305dpi Print Resolution
DESCRIPTION
4-3
PN: 9001155A