ACCESSORIES INSTALLATION
This chapter covers printer accessory installation procedures that are operator allowed.
INTERFACE INSTALLATION
The diagram below displays the physical installation of interface hardware. Refer to the Configuration unit of this
manual for instructions on printer setup for the interface type chosen.
1.
Switch off the printer and disconnect power supply cord.
2.
Route interface cable (1, Figure 3-7) from host computer to interface board (2).
3.
Insert interface board (2) into printer (4) and secure using two screws (3).
4.
Connect interface cable (1).
LM408-412e Operator Manual
Unit 3: Installation
Figure 3-7, Interface Installation
3-16
PN: 9001155A