IBM System x3650 M4 Type 7915 Installation And User Manual page 164

146
System x3650 M4 Type 7915: Installation and User's Guide
Select this choice to view or change the server component settings.
– Processors
Select this choice to view or change the processor settings.
– Memory
Select this choice to view or change the memory settings.
– Devices and I/O Ports
Select this choice to view or change assignments for devices and input/output
(I/O) ports. You can configure the serial ports, configure remote console
redirection, and enable or disable integrated Ethernet controllers. If you
disable a device, it cannot be configured, and the operating system will not be
able to detect it (this is equivalent to disconnecting the device).
– Power
Select this choice to view or change power capping to control consumption,
processors, and performance states.
– Operating Modes
Select this choice to view or change the operating profile (performance and
power utilization).
– Legacy Support
Select this choice to view or set legacy support.
- Force Legacy Video on Boot
Select this choice to force INT video support, if the operating system does
not support UEFI video output standards.
- Rehook INT 19h
Select this choice to enable or disable devices from taking control of the
boot process. The default is Disable.
- Legacy Thunk Support
Select this choice to enable or disable UEFI to interact with PCI mass
storage devices that are non-UEFI compliant.
– Integrated Management Module
Select this choice to view or change the settings for the integrated
management module.
- Commands on USB Interface Preference
Select this choice to enable or disable the Ethernet over USB interface on
IMM2.
- Network Configuration
Select this choice to view the system management network interface port,
the IMM2 MAC address, the current IMM2 IP address, and the host name;
define the static IMM2 IP address, subnet mask, and gateway address;
specify whether to use the static IP address or have DHCP assign the
IMM2 IP address; save the network changes; and reset the IMM2.
- Reset IMM to Defaults
Select this choice to view or reset IMM2 to the default settings.
- Reset IMM
Select this choice to reset IMM2.
– System Security
Select this choice to view or configure Trusted Platform Module (TPM)
support.
– Adapters and UEFI Drivers