IBM System x3650 M4 Type 7915 Installation And User Manual page 151

5. Download the latest version of drivers.
– Emulex iSCSI Device Driver for Windows 2008
– Emulex FCoE Device Driver for Windows 2008
Note: Changes are made periodically to the IBM website. The actual procedure
might vary slightly from what is described in this document.
v Port 0 on the Emulex dual port 10GbE SFP+ Embedded VFA III adapter can be
configured as shared system management.
v When the server is in standby mode, both ports on the Emulex dual port 10GbE
SFP+ Embedded VFA III adapter function at 100M connection speed with Wake
on LAN feature.
The Emulex dual port 10GbE SFP+ Embedded VFA III adapter is automatically
disabled if one of the following errors occurs:
v An error log indicates a temperature warning for the Ethernet adapter.
v All power supplies are removed or the server is disconnected from the power
source.
To install the network adapter, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
on page 40.
2. Turn off the server and peripheral devices and disconnect the power cords.
3. Remove the cover (see "Removing the cover" on page 54).
4. Remove the PCI riser-card assembly (if installed) from PCI riser connector 2
(see "Removing a PCI riser-card assembly" on page 55).
5. Remove the adapter filler panel on the rear of the chassis (if it has not been
removed already).
6. Touch the static-protective package that contains the new adapter to any
unpainted metal surface on the server. Then, remove the adapter from the
package.
Network adapter
filler panel
Chapter 2. Installing optional devices
133