Assembly - Jet JJP-8BT Operating Instructions And Parts Manual

8" jointer-planer
Hide thumbs Also See for JJP-8BT:
Table of Contents

Advertisement

Assembly

For
assembly
convenience,
designators used throughout the Assembly section
are the same as those used to identify shipping
content and hardware components on pages 8–9.
Stand Assembly
Note: If you do not plan to use a standat this time,
skip this page and proceed to Jointer-Planer
Assembly on the following page.
Referring to Figure 7:
1. Select two legs (S
support (S
) and one short support plate (S
D
2. Attach one end of the stand top support (S
the top of the first leg with two carriage bolts
(S
), flat washers (S
G
hex nuts (S
). Attach the other end of the
K
stand top support (S
same manner. Hand-tighten only at this time.
3. Attach a support plate (S
the same manner with two carriage bolts (S
flat washers (S
), lock washers (S
H
nuts (S
). Hand-tighten only at this time.
K
4. Repeat steps 1–3 using the remaining legs,
short stand top support and support plate.
5. Complete the stand construction by attaching
long stand top supports (S
plates (S
) to the leg assemblies constructed
A
in steps 1–4. Hand-tighten all hardware only at
this time.
6. Place a rubber foot (S
(S
), then insert the threaded end of the screw
F
through the opening on the bottom of the leg.
7. Secure with flat washer (S
8. Attach rubber feet to remaining legs in the
same manner.
9. Place stand upright. Ensure that the stand is
on a level surface and all four legs are
contacting the surface.
10. Tighten
all
hex
wrench (U, Fig. 4) provided.
Mounting Jointer-Planer to Stand
Referring to Figure 8:
1. Place the Jointer-Planer (D) onto the assembled
stand and secure with 4 socket head cap
screws (S
), lock washers (S
M
washers (S
).
N
2. Tighten all socket head cap screws (S
the 5mm hex wrench (W, Fig. 4) provided.
the
item
letter
), one short stand top
E
B
) to
D
), lock washers (S
) and
H
J
) to the second leg in the
D
) to each leg (S
) in
B
E
) and hex
J
) and long support
E
) on a hex cap screw
Q
) and hex nut (S
).
H
K
nuts
with
the
10mm
), and flat
P
) with
M
S
S
S
H
K
J
S
K
S
S
J
H
).
),
G
S
A
10
S
G
S
D
S
B
S
G
S
E
S
C
S
K
S
H
S
Q
S
F
Figure 7
Figure 8

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents