Installing The Optional Cinewide With Autoscope Lens Motors - Runco 3Dimension D-113d Installation & Operation Manual

Your D-113d/CineWide with AutoScope may have shipped with the
Note
AutoScope lens motors pre-installed. If so — or if you are installing
a standard D-113d (without an anamorphic lens) — skip this step
and proceed with Assembling the Projection System (page 30).
If you are installing a D-113d/CineWide with AutoScope, proceed as follows to install the
lens mount/motor assemblies on the top and bottom projection units.
1. Do not install the CineWide lens yet, only the AutoScope lens
Note
2. Some components shipped with your projector may differ slightly
1. Carefully unpack the top and bottom projection units.
2. Place the top projection unit (the one with the cosmetic caps on the top) upside down
on a smooth, flat surface covered with a blanket or other soft material.
3. Line up the eight mounting holes on the lens motor housing with those on the bottom
of the top projection unit. Secure the motor to it with the eight screws provided for this
purpose. See Figure 3-6.
Figure 3-6. Attaching the AutoScope Lens Motor to the Projection Unit
D-113d Projection System Installation/Operation Manual
motor. You will install the CineWide lens after you install the
projector and adjust the primary lens.
from what is shown in these instructions.
29
Installation
3.4
Installing the Optional
CineWide with
AutoScope Lens
Motors