Table of Contents
Advertisement
Installation
Table 3-6. D-113d Optical Alignment Procedure (with Anamorphic Lenses) (continued)
DHD
1.
Select Calibration -> Adjustment Mode
and set it to Secondary.
2.
Select Service -> Display Device ->
Configure -> Lens.
DHD
1.
For a rear-projection installation, select
Service -> Display Device ->
Configure -> Installation ->
Picture Orientation and set it as needed.
2.
Select Calibration -> Image Alignment
-> Corner Alignment, check the Primary
Test Pattern and Secondary Test
Pattern boxes and adjust corners.
3.
Select Calibration -> Image Alignment
-> Midpoint Alignment, check the
Primary Test Pattern and Secondary
Test Pattern boxes and adjust midpoints.
DHD
1.
Select Calibration -> Adjustment Mode
and set it to Both.
2.
Assign 12-volt trigger outputs to Cinema
and Virtual Cinema aspect ratios; refer to
Configure Lens Motor Trigger
(CineWide with AutoScope) on page 58.
3.
Select Aspect Ratio and set it to Cinema.
On a D-113d/CineWide with AutoScope,
this should position the anamorphic lens
transport in front of the primary lenses.
4.
Select Service -> Test Video and choose
Primary Alignment.
DHD
1.
Select Service -> Test Video and choose
Secondary Alignment.
Projector (Align Secondary/Right
Image with Screen)
1.
Adjust Focus using the focus test
pattern.
2.
Adjust Zoom and Position using the
outer edge of your image as a guide.
Make sure your source is using the
entire 1080p frame. A 100% white
image would be best for this step.
You may need to readjust Focus after
this step.
3.
Remove the cover from the top
projector lens.
Projector
No adjustment needed.
Projector
1.
Install anamorphic lenses.
2.
Align the primary (left-eye) image with
the screen by adjusting the Left (top)
anamorphic lens to produce the least
amount of distortion.
Projector
1.
Align the secondary (right-eye) image
to the screen by adjusting the Right
(bottom) anamorphic lens to produce
the least amount of distortion.
50
Note: The default warp is 46 pixels on
the left and right sides (x) and 26 pixels at
the top and bottom (y). If more is
needed, use the "Image Alignment"
controls to increase it.
D-113d Projection System Installation/Operation Manual
Advertisement
Table of Contents
Troubleshooting
