Parksense® Front And Rear Park Assist - Jeep Grand Cherokee User Manual

OPERATING YOUR VEHICLE
Air Recirculation
• Use Recirculation for maximum A/C operation.
• For window defogging, turn the recirculation button off.
• If the recirculation button is pushed while in the AUTO mode, the indicator light
may flash three times to indicate the cabin air is being controlled automatically.
Heated Mirrors
• The mirrors are heated to melt frost or ice. This feature is activated whenever you
turn on the rear window defroster.
PARKSENSE® FRONT AND REAR PARK ASSIST
• ParkSense can be enabled and disabled by pressing the ParkSense
®
located below the climate controls, on the switch panel.
• The four ParkSense
behind the vehicle that is within the sensors' field of view. The sensors can detect
obstacles from approximately 12 in (30 cm) up to 79 in (200 cm) from the rear
fascia/bumper in the horizontal direction, depending on the location, type and
orientation of the obstacle.
• The six ParkSense
in front of the vehicle that is within the sensors' field of view. The sensors can
detect obstacles from approximately 12 in (30 cm) up to 47 in (120 cm) from the
front fascia/bumper in the horizontal direction, depending on the location, type
and orientation of the obstacle.
• When an object is detected within two meters behind the rear bumper while the
vehicle is in REVERSE, a warning will display in the Electronic Vehicle Information
Center (EVIC) and a chime will sound (when Sound and Display is selected from
the Customer Programmable Features section of the Uconnect
As the vehicle moves closer to the object, the chime rate will change from single
1/2 second tone (for rear only), to slow (for rear only), to fast, to continuous.
Cleaning the ParkSense® Sensors
• If "CLEAN PARK ASSIST SENSORS" appears in the Electronic Vehicle Informa-
tion Center (EVIC), clean the ParkSense
soft cloth. Do not use rough or hard cloths. Do not scratch or poke the sensors.
Otherwise, you could damage the sensors.
NOTE:
When the Instrument Cluster reads either Clean Sensor or Blinded, please clean off
the bumper sensors to see if the condition is corrected.
38
sensors, located in the rear fascia/bumper, monitor the area
®
sensors, located in the front fascia/bumper, monitor the area
®
® sensors with water, car wash soap and a
switch
®
System screen).
®