Blade Control Lever
to lower the mower deck and engage the blades, lift
the lever up off the lock notch and lower slowly.
WARNING!
No adjustments or maintenance to be
carried out unless:
♦
the engine stopped
♦
the ignition key removed
♦
the parking brake activated
Manual Transport
When pushing or pulling the mower, be sure to engage
the EZt Hydrogear bypass linkages. the EZt bypass
linkages are located on the rear of the frame, below
the rear engine guard.
•
Raise the deck into the highest cutting position.
•
Pull the EZt bypass linkages out and into the
slots. Release linkages to hold in the bypass
position.
•
Release park brake.
•
to reengage the EZt's to drive, reverse the
above procedure.
22 - HUSQVARNA
CONtROLS
Mower deck blade control lever in the disengaged position
Set bypass linkages into slots on both sides
8050-016
8050-018