Fuel Shut Off Valve; Mower Deck Lifting Lever; Blade Control Lever; Tracking - Husqvarna RZ4219 Operator's Manual

Fuel Shut Off Valve

The fuel shut off valve is located in the fuel line under the
seat. Tilt seat forward for access. The fuel valve is ON when
the valve is parallel to the fuel line. Rotate the valve ¼ turn
clockwise to turn fuel OFF.

Mower Deck Lifting Lever

The lifting lever is used to place the mower deck in the
transport position or one of the 6 different cutting height
positions.
The cutting height is set by placing a lever in the notch for the
desired cutting height.
The lifting lever can also be used to temporarily adjust the
cutting height, such as when passing a minor bump in the
lawn.
IMPORTANT INFORMATION To obtain an even cutting
height, it is important that the air pressure in all tires is 15
psi / 103 kPa / 1 bar.
IMPORTANT INFORMATION Always raise the deck to the
highest position for transport.
CONTROLS

Blade Control Lever

To engage the mower blades, slowly lift the lever up and into
the lock notch.

Tracking

If the mower is not tracking straight, check the air pressure
in both rear tires. Recommended air pressure is 15 psi. (1
bar) Tracking must be checked on a flat and level concrete or
blacktop surface. If the unit still does not track straight contact
your Husqvarna workshop for adjustments.

Bypass Linkages

Transaxle bypass linkages must be engaged when pushing or
pulling the mower. The release levers are located on each side
of the rear of the unit below the rear engine plate. See Moving
Machine By Hand in the Operation section.
WARNING! Bypass linkages are located close to
the muffler. To prevent burns, the engine should be shut off
and allowed to cool before the bypass linkage levers are
handled.
14