Blade.control.lever; Manual.transport - Husqvarna RZ4216 Operator's Manual

Blade Control Lever
To engage the mower blades, slowly lift the lever up
and into the the lock notch.
WARNING!
No adjustments or maintenance to be
carried out unless:
• the engine stopped
• the ignition key removed
• the parking brake activated
Manual Transport
When pushing or pulling the mower, be sure to
engage the EZT Hydrogear bypass linkages. The EZT
bypass linkages are located on the rear of the frame,
below the rear engine guard.
• Raise the deck into the highest cutting position.
• Pull the EZT bypass linkages out and into the
slots. Release linkages to hold in the bypass
position.
• Release park brake.
• To reengage the EZT's to drive, reverse the above
procedure.
22
ContRoLs
Mower deck blade control lever in the disengaged position
Set bypass linkages into slots on both sides
8058-074
8050-018