Assembling Herc-U-Lift™ Caster System To Saw; Installation Instructions - RIDGID Contractor TS2424 Owner's Manual

Assembling Herc-U-Lift™ Caster System to
Saw

Installation Instructions

WARNING: To reduce the risk of injury from unex-
pected starting, unplug the tool before attaching
caster set.
1. From the bag of loose parts remove the following hard-
ware:
*4 Screw Special 1/4-20 x 1-5/8
*8 Washer 1/4 I.D.
*4 Nut Lock 1/4-20
*8 Screw Hex Hd. 1/4-20 x 1/2
*8 Lockwasher 1/4
*8 Nut Hex 1/4-20
2. From the bag of loose parts remove the following:
4 Leg Brackets
3. Install the four leg brackets on the inside of each leg
using 1/4-20 x 1/2 hex head bolts, lockwashers and
nuts. Tighten bolts securely.
4. It may be helpful to place the saw leg stand assembly
on blocks of wood approximately 3/4 inches thick while
installing the caster assemblies.
5. Place the Lower Assembly under the saw with the front
ends of the tube under the front leg brackets. Install the
special screw (1/4-20 x 1-5/8) through the front leg
bracket and tube as shown. Install the washer (each
side) and lock nut and tighten the lock nuts until flush
with bottom of screw. The screw should freely pivot
side to side.
6. Place the upper assembly under the saw (see illustra-
tion) with the rear ends of the tube under the leg brack-
ets and install the special screw (1/4-20 x 1-5/8),
washer (each side) and nut in the same manner as
step 5. Center the upper tubes between the lower
tubes and tighten all hardware at this time beginning
with the four (4) bolts attaching the plate assembly to
the tubes.
7. Insure the upper tubes remain centered between the
lower tubes and tighten the hardware on the lower
assembly.
8. Press down on the plate assembly and check align-
ment of the U-bolt. The U-bolt should be centered
within the latch mechanism as shown. Release pedal
and adjust the U-bolt as necessary, then tighten the
nuts holding the U-bolt to the tube.
1/4-20 x 1-5/8
Screw Special
1/4-20 x 1/2
1/4-20
Screw Hex Hd.
Nut Lock
Wood
Block
Adjust U-Bolt
Centered Within
Latch Mechanism
U-Bolt
23
1/4 Lockwasher
1/4 I.D. Washer
Leg Bracket
Plastic Ring
1/4-20
Nut Hex
Center Frames Equal
Distance on Each Side
Tighten all Nuts
Latch
Mechanism