Assembling Herc-U-Lift™ Caster System; Assembly Tips; Upper Assembly - RIDGID Contractor TS2424 Owner's Manual

Assembling Herc-U-Lift™ Caster System

Assembly Tips

1. The caster set consists of an upper and lower assem-
bly.
2. First put the upper and lower assembly together follow-
ing instructions below.
3. Finger tighten all nut and bolt connections. After
mounting the assemblies on the table saw, adjust
frames on center, and then securely tighten all fasten-
ers.
4. When assembling the frames, Tube Rear (27" long)
and Tube Front (13-7/8" long) must be assembled so
the large hole faces down towards the floor. See the
illustration before assembling.

Upper Assembly

1. From bag of loose parts remove the following hard-
ware:
*4 Hex Head Screw, 1/4-20 x 1-1/2
*8 Washers 1/4 ID
*4 Lockwashers 1/4
*4 Hex Nuts 1/4
*2 Washers 7/16 ID
*2 Hex Nuts 7/16
* Items marked with asterisk (*) are shown actual size.
2. From the loose parts find the following:
1 Plate Assembly
2 Tube Rear (27" Length)
1 Channel Rear
2 Casters
3. Assemble Tube Rear (27 inch length) to each side of the
Plate Assembly as shown using four each 1/4-20 x 1-1/2
hex head bolt, flat washer (each side), lockwasher and
nut. Finger tighten nuts.
NOTE: The larger hole at the end of the tube, opposite
the plate assembly, must face down.
4. Align rear channel with holes in the rear tubes as
shown. Assemble caster through channel and tube as
shown. Fasten with flat washer and 7/16 nut as shown.
Finger tighten nuts.
1/4 I.D.Washer
7/16 I.D. Washer
Plate Assembly
Tube Rear
Plate
Assembly
21
1/4-20 x 1-1/2
Hex Head Screw
1/4 I.D.
Lockwasher
Hex Nut
7/16 Hex Nut
Tube Rear
Channel Rear
Caster
Large Hole
Facing Down
Tube Rear
1/4-20
Channel
Rear