Grizzly G0555LX Owner's Manual page 19

4.
turn the stand assembly upright and attach
the top, as shown in figure 11, with (8)
18 x ⁄ " carriage bolts and (8)
5
8
nuts.
x 8
figure 11. stand top attached.
5.
square up the stand components and fully
tighten all the fasteners.
6. place the level on top of the stand assembly,
as shown in figure 12, then adjust the feet
up or down to make the stand top level from
side to side and front to back. Make sure that
both hex nuts on the feet are tight against the
stand assembly so they will not move.
figure 12. leveling the stand.
G0555LX (Mfg. Since 3/13)
7.
5 ⁄ "-
16
⁄ "-18 flange
5
16
8.
figure 13. bandsaw assembly attached to the
9.
With the help of other people, lift the bandsaw
assembly onto the stand and align the mount-
ing holes. have one person hold the bandsaw
in place to keep it from fall until you can com-
plete the next step.
secure the bandsaw assembly to the stand
with (4) ⁄ "-18 x 1 ⁄ " hex bolts, (4)
5 1
16 2
washers, (8) ⁄ " flat washers, and (4)
5
16
hex nuts, as shown in figure 13.
x 4
stand.
position the table trunnion on the bandsaw,
as shown in figure 14, then secure it with the
(2) ⁄ "-18 x 1 ⁄ " hex bolts and (2)
5 1
16 4
washers.
x 2
figure 14. trunnion installed.
⁄ " lock
5
16
⁄ "-18
5
16
⁄ " lock
5
16
trunnion
-17-