Aligning Fence
To check/align the fence parallel with the
miter slot:
1.
2.
Figure 30.
3.
4.
NOTICE
Adjusting the fence parallel to the miter slot
does not guarantee straight cuts. The miter
slot may need to be adjusted parallel to the
side of the blade, which is covered in the
Aligning Table instructions on Page 25.
Step 2
Figure 30
Miter Gauge
To calibrate the miter gauge:
1.
Figure 31
Figure 31.
2.
3.
Note: Sometimes the tightening procedure
can affect the adjustment.
4.
5.
6.
7.
Steps 1–4