Aligning Fence; Off Button; Motor Brake - Grizzly G0531B Owner's Manual

5.
Twist the OFF button clockwise so it pops
out. When the OFF button pops out, the
switch is reset and ready for operation (see
Figure 5).

OFF Button

Figure 5. Resetting the switch.
6. Turn the switch disabling key to "0", as shown
in Figure 4.
7. Try to turn the machine ON.
—If the bandsaw does not start, the switch
disabling feature is working as designed.
The Test Run is complete.
—If the bandsaw starts, immediately discon-
nect power. The switch disabling feature is
not working correctly. This safety feature
must work properly before proceeding with
regular operations. Call Tech Support for
help.

Motor Brake

The motor brake is activated automatically when
the OFF button is pushed, quickly bringing the
blade to a stop.
Model G0531B/G0566B (Mfd. Since 09/18)

Aligning Fence

To ensure cutting accuracy when the fence is first
installed, the fence should be aligned with the
miter slot.
To align fence parallel with miter slot:
1. DISCONNECT MACHINE FROM POWER!
2. Make sure miter slot is aligned with bandsaw
blade (see G0566 Manual Page 22, Table
Alignment).
3.
Mount fence next to miter slot, then loosen
knobs and cap screw that secure fence rail to
the table.
4. Adjust fence face parallel with edge of the
miter slot, as shown in Figure 6.
Figure 6. Example of fence square with miter
slot.
5.
Tighten knobs and cap screw that secure rail
to the table, being careful not to move the
fence.
NOTICE
Adjusting the fence parallel to the miter
slot does not guarantee straight cuts. The
miter slot may need to be adjusted paral-
lel to the side of the blade. Refer to the
"Table Alignment" instructions in the G0566
Manual on Page 22.
-3-