Grandstream Networks GXP1450 User Manual page 34

SIP User ID
Authenticate ID
Authenticate Password
Name
DNS Mode
Primary IP
Backup IP 1
Backup IP 2
TEL URI
SIP Registration
Unregister on Reboot
Register Expiration
Reregister Before
Expiration
Local SIP Port
SIP Registration Failure
Retry Wait Time
SIP T1 Timeout
SIP T2 Interval
SIP Transport
SIP URI Scheme when
using TLS
Grandstream Networks, Inc.
User account information provided by VoIP service provider (ITSP); either an actual
phone number or formatted like one.
SIP service subscriber's Authenticate ID used for authentication. It can be identical
to or different from SIP User ID.
SIP service subscriber's account password for GXP1450 to register to (SIP) servers
of ITSP.
SIP service subscriber's name that is used for Caller ID display.
The default is set to A Record. If user wishes to locate the server by DNS SRV,
the user may select SRV or NATPTR/SRV. When "Use Configured IP" option is
selected, if SIP server is configured as domain name, phone will not send DNS
query, but use "Primary IP" or "Secondary IP" to send sip message if at least one
of them are not empty.
This option applies only if "Use Configured IP" is selected, the phone will send DNS
query to the Primary IP. Insert IP address here.
Insert the first back up IP here.
Insert the second back up IP here.
Default is "Disabled". If the phone has an assigned PSTN telephone number, this
field should be turned on and a "User=Phone" parameter will be attached to the
"From" header in SIP request.
This parameter controls sending REGISTER messages to the proxy server. The
default setting is "Yes".
Default is "No". If set to "Yes", the SIP user's registration information will be cleared
on reboot.
This parameter allows user to specify the time frequency (in minutes) that GXP1450
refreshes its registration with the specified registrar. The default interval is 60
minutes. The maximum interval is 65,535 minutes (about 45 days).
This parameter allows user to specify the time frequency (in seconds) that
GXP1450 sends out a re-registration request before the Register Expiration. By
default is 0 second.
This parameter defines the local SIP port used to listen and transmit. The default
value for Account 1 is 5060 and 5062 for Account 2.
Retry registration if the process failed. Default is 20 seconds.
RFC 3261 SIP T1 timer. Default is 0.5 second.
RFC 3261 SIP T2 timer. Default is 4 seconds.
Choose SIP Transport between UDP and TCP. Default is UDP.
Select "sip:" or "sips:". Default is "sips:".
GXP1450 User Manual
Firmware 1.0.1.110
Page 33 of 42
Last Updated: 01/2012