Removing Or Providing A Fitness Test; Changing The Custom Programs; Viewing The Odometer, Hours Of Use, Software Version, Error Log And Serial Number - Precor C966i Owner's Manual

C O M M E R C

REMOVING OR PROVIDING A FITNESS TEST

The Fitness Test is "enabled" at the factory (program number 16), so if you wish to
remove the option from the user's choice of programs on the C996i, you need to
"disable" the Fitness Test.
Important: If you "disable" the Fitness Test, it is no longer available to the user.
Custom Program 2 takes its place as program number 16.
After displaying a cool down time limit and entering your selection, the Fitness Test
prompt appears on the display. Use the ▼▲ keys to select "enabled" or "disabled".
Press ENTER to confirm your selection.

CHANGING THE CUSTOM PROGRAMS

Two custom programs (Program 1 and Program 2) exist in the C996i treadmill.
After you modify Program 1 (or opt to bypass it), Program 2 appears on the
display. The keys on the console keypad have a different function than explained
in the box on page 21. In the Custom Programs, the keys function as follows:
Custom Program Keys
SPEED ▼ or ▲
INCLINE ▲ or ▼
ENTER
STOP or RESET
If you decide to select a custom program, you have the ability to create a new, or
"draw over" an existing, program profile. The entire program appears on the dis-
play. A blinking LED appears at the top of the far left column and indicates the
starting position. Any incline changes that you make occur only in that column.
The treadmill's speed is determined by the user.
Begin modifying the program profile using any INCLINE ▲ or ▼ key. The available
incline range is a negative 3% to a positive 15%. To move onto the next column,
press any SPEED ▼ or ▲ key. (Refer to the chart above.)
When you have finished making changes, press ENTER to save the program
profile. The display moves to the next Custom Program (#2) or returns to the
Precor banner (depending on which Custom Program you were modifying).
Note: To exit the custom program mode without saving any of the changes, press
STOP or RESET. The custom program that existed prior to your changes is
reinstated and the display returns to the Precor banner.
VIEWING THE ODOMETER, HOURS OF USE, SOFTWARE
VERSION, ERROR LOG AND SERIAL NUMBER
The treadmill stores the cumulative miles or kilometers, the number of hours that
the unit has been in use, the software version and software type (which is valuable
when calling customer support), and an error log (useful when troubleshooting).
page 24
I A L P R O D
moves the blinking LED from column to column.
affects the incline of the selected column.
accepts any changes and stores the program in memory.
exits the program (leaving it unchanged) and resets the
display to the Precor banner.
U C T S D I V I S I O N