Table of Contents
Advertisement
•
Speaker
impedance
SF::'iMP,,
Use this feature to set the speaker impedance of this unit
so that it matches that of your speakers.
Choices: 8f2MIN, 6_QMIN
•
Select "8_OMIN" to set the speaker impedance to 8 _(-2.
•
Select "6_OMIN" to set the speaker impedance to 6 _(-2.
8_MIN
6_MIN
Front
lfyou use one set (A or B),
the impedance of each
speaker must be 8 o or
higher.
If you use two sets (A and
B), tile impedance of each
speaker must be 16 _ or
higher."
Center
The impedance of each
Surround
speaker must be 8 o or
higher.
Surround back
Front
lfyou use one set (A or B),
the impedance of each
speaker must be 4 o or
higher.
If you use two sets (A and
B), the impedance of each
speaker must be 8 o or
higher.
Center
The impedance of each
Surround
speaker must be 6 o or
higher.
Surround back
The Canada model cannot use two separate speaker systems
(A and B) simultaneously
when "SP IMR" is set to "Sf2MIN".
•
Factory presets
F::'F;;:ESET
Use this feature
to reset all the parameters
of this unit to
the initial factory
settings
(see page 97).
Choices:
CANCEL,
RESET
•
Select "CANCEL"
not to reset any parameters
of this
unit.
•
Select "RESET"
to reset the parameters
of this unit.
•
Remote control AMP ID
REi4OTEI:::Ii4i:::'
Use this feature
to set the AMP ID of this unit for remote
control
recognition
(see page 93).
Choices:
ID1, ID2
•
Select
"IDI"
when the remote
control
AMP ID library
code is set to "00001 ".
•
Select
"ID2"
when the remote
control
AMP ID library
code is set to "00002".
Note
You need to set the corresponding remote control AMP library
code lor the rmnote control (see page 93).
•
Remote
control
TUNER
ID
i:;;:EM0M!!!I [ i...ii..i
Use this feature
to set the TUNER
ID of this unit for
remote
control
recognition
(see page 93).
Choices:
ID1, ID2
•
Select
"IDI"
when the remote
control TUNER
ID
library code is set to "81916".
•
Select
"ID2"
when the remote
control TUNER
ID
library code is set to "81917".
You need to set the corresponding
remote control TUNER library
code lor the rmnote control (see page 93).
•
Remote
control
XM ID
Ri!!!MOii!!!',:.:1i,i
(U.S.A.
model
only)
Use this feature to set the XM ID of this unit for remote
control recognition (see page 94).
Choices: ID1, ID2
• Select "IDI" when the remote control XM ID library
code is set to "81918".
• Select "ID2" when the remote control XM ID library
code is set to "81919".
You need to set the corresponding remote control XM library
code lor the remote control (see page 93).
• This setting completely resets all the parameters of this unit
including the "SET MENU" parameters. However. the
advanced setup melm parameters will not be initialized.
• The initial lhctory settings are activated next time you turn on
this unit.
89
Advertisement
Table of Contents
