Table of Contents
Advertisement
Recording
adjustments
and other operations
are performed
from the recording
components.
Refer to the operating
instructions
for those components.
['_'_, f Ij/l'oJAvl
The DTS signal is a digital bitstream. Attempting to digitally record the DTS bitstream will result in
noise being recorded. Therefore, if you want to use this unit to record sources encoded in DTS, the
following
considerations
and adjustments need to be made. To play DTS-encoded
DVDs and CDs
(when using a digital audio connection)
on your DTS-compatible
player, follow
its operating
instructions to make a setting so that the analog signal will be output from the player.
• When this unit is set to the standby mode, you cannot record between other components commcted to this unit.
• The setfings of TONE CONTROL (see page 32), VOLUME, the speaker level (see page 80) and the sound field programs (see
page 64) do not affect the recorded materiah
• The source connected to the MULTI CH INPUT jacks of this unit cannot be recorded.
• S-video and composite video signals pass independently
through the video circuits of this emit. Therefore, when recording or dubbing
video signals input from a video source component that provides only ale S-video or a composite vide() signal, you can record only an
S-video or a composite video signal on your VCR.
• Digital signals input at the DIGITAL INPUT.jacks are not output at the analog AUDIO OUT (REC)jacks
lor recording. Likewise,
analog signals input al the AUDIO IN or PORTABLE jacks are not output at the DIGITAL OUTPUT.jack.
Therefore, if your source
component is connected to provide only digital or analog signals, you can only record digital or analog signals.
• A given input source is not output on the same OUT (REC) channeh
• Check the copyright laws in your country to record li"om CDs, radio, etc. Recording of copyrighted
material may infringe copyright
laws.
• The XM Satellite Radio (U.S.A. model only) signals calmot be output at the AUDIO OUT (REC).jacks.
• The analog audio sigmds input at the DOCK terminal can be output at the analog AUDIO OUT (REC).jacks for recurding.
-#-
Do
a test recording belore you start ale actual recording.
If you play back a video source
that uses scrambled
or encoded
signals
to prevent
it from being dubbed,
the picture
itself may be disturbed
due to those signals.
(U.S.A.model)
1
Turn on all the connected components.
Rotate the INPUT selector on the front panel
(or press one of the input selector buttons on
the remote control) to select the source
component you want to record from.
Front panel
Remotecontrol
3
Start playback on the selected source
component or select a broadcast station.
4
Start recording on the recording component.
(U.S.A.
model)
44
Advertisement
Table of Contents
