Foxconn K8S760MG series User Manual page 22

Power Supply
This motherboard uses an ATX power supply. In order to avoid damaging any
devices, make sure that they have been installed properly prior to connecting
the power supply.
ATX 12V Power Connector: PWR2
The 4 pin ATX 12 V power supply connects to PWR2 and provides power to the
CPU.
ATX Power Connector: PWR1
PWR1 is the ATX power supply connector. Make sure that the power supply
cable and pins are properly aligned with the connector on the motherboard.
Firmly plug the power supply cable into the connector and make sure it is secure.
Attention:
You have to press the power button for more than four seconds if
you change the default Instant-off setting to "Delay 4 Sec" for the
"Soft-Off by Power Button" option in the BIOS Power Management
Setup.
15
Chapter 2 Installation Instructions
3D3V_SYS 5V_SYS 5V_SYS
3D3V_SYS Ground Ground Ground
1
11
3D3V_SYS Ground Ground
-12V_SYS PS-ON Ground
ATX Power Connector
G N D
12V
ATX 12V Power Connector
2004-9-14, 8:41
Power OK 12V_SYS
5V_SB
10
20
Ground 5V_SYS
NC 5V_SYS
GND
12V
15