Table of Contents
Advertisement
HDD Connectors: PIDE & SIDE
These connectors support the provided Ultra DMA133/100/66 IDE hard disk
ribbon cable. Connect the cable's blue connector to the primary (recommended)
or secondary IDE connector, then connect the gray connector to the Ultra DMA133/
100/66 slave device (hard disk drive) and the black connector to the Ultra DMA133/
100/66 master device. If you install two hard disks, you must configure the
second drive as a slave device by setting its jumper accordingly. Refer to the
hard disk documentation for the jumper settings.
Attention:
Ribbon cables are directional, therefore, be sure to always connect
with the cable on the same side as pin 1 of the PIDE/SIDE or
FLOPPY connector on the motherboard.
19
Chapter 2 Installation Instructions
SIDE
1
PIDE
2004-9-14, 8:41
19
Advertisement
Table of Contents
